How to fix no audio from Clear-Com WBS-670?
If you are not getting any audio from your Clear-Com Intercom System headsets, check the Transmitter switch on both the base and beltpack. Also, check the talk LED to ensure it is on, and verify that the beltpack batteries are in good condition.
How to fix distortion on Clear-Com WBS-670?
If your Clear-Com Intercom System's audio quality seems distorted at medium to high input levels, reduce the microphone gain by adjusting the microphone gain control.
Why does my Clear-Com WBS-670 Intercom System pick up interference?
If your Clear-Com Intercom System picks up signals other than wireless intercoms, ensure that all beltpacks are turned on. For any unused receivers at the base, turn the audio off by deselecting the appropriate “Beltpack Connect” button. If the issue continues with the beltpack on, changing the group might be necessary. Ensure the base and beltpack settings match after any Group/Channel change.
What to do if my Clear-Com WBS-670 Intercom System has dropouts?
If you experience dropouts with your Clear-Com Intercom System while moving around, ensure that both antennas on the base and beltpack are connected and follow the location suggestions. Try changing the location of the base unit and antennas or avoid the problematic areas with the remote beltpacks.
Why does my Clear-Com WBS-670 Intercom System produce feedback?
If you are experiencing feedback, like a squeal or howl, from your Clear-Com Intercom System when moving around the area, it may be because the gain settings on both the beltpacks and the base are too high. Reduce the gain settings on both the beltpacks and the base.
General| RF Output Power | 100 mW |
|---|---|
| Operating Temperature | -4° to +131°F (-20° to +55°C) |
| Power Requirements | 12 VDC |
| Battery Life | Up to 12 hours |
| Connector | XLR |
Provides detailed technical specifications for the WBS-670 Base Station.
Provides detailed technical specifications for the WTR-670 Beltpack.
Guides on connecting, polarizing, spacing, and placing antennas for optimal performance.
Covers base station location, power connection, and transmit switch configuration.
A checklist to ensure all setup steps are completed before system operation testing.
Covers beltpack operation, controls, and basic functions.
Guide for testing system performance in the intended operating areas.
Provides solutions for common problems encountered with the wireless intercom system.
Covers FCC licensing requirements and mandatory safety instructions for equipment operation.
To Next Page