Special Key Sequences
Lockout
•
Press [UP]+[DOWN] for 3 seconds to lock or unlock the
base station. Pressing [MENU] will still function to view
screens, but [SET] will no longer start any editing. Scan,
First use, Factory default are no longer accessible. The in
-
tercom front panel 2-wire/4-wire selection is also locked
into place. A padlock icon will be displayed on the second
line of the display to the far left as an indication that the
base station is locked out.
Copy
•
Press [SET]+[DOWN] for 3 seconds to copy any cur
-
rently displayed group to a user-programmable group.
Copy can be done from the group/channel select,
group/frequency select, or frequency edit screen. Once
pressed, the words, “Copy to” are displayed on the screen
with the first empty user-programmable group flashing. If
all the user-programmed groups were full, than the first
programable group is displayed. The [UP] or [DOWN]
buttons may be used to select a different user-programmable
group if desired. Pressing [SET] pastes frequencies/chan-
nels to the group and take the user to the frequency edit
screen with "Tx” flashing.
1
st
Use Default
•
Press [MENU] while turning on the base station to enter
the 1
st
use default setup screen. This places the unit on
group 01A with the four receivers set to channels 1- 4 of
the group. Any user-programmed frequencies that had
been entered previously are retained. If lockout had
been activated, the beltpack comes up where it was last
left regardless of [MENU] being pressed on power-up.
Factory Default
•
Pressing all four buttons [MENU]+[SET]+[UP]+[DOWN]
at the same time for 3 seconds places the unit on group
01A with the four receivers set to channels1–4ofthat
group. This is just like base station 1
st
use default, except
that all user-programmed frequencies that had been en
-
tered previously are erased. This function may take sev
-
eral seconds. If lockout had been activated, the beltpack
comes up where it was last left regardless of these four
keys being pressed.
6-10
To Next Page
Loading...
