15
3. Line up the keyholes on back of the phone over
the screws, and slide the phone downward until
it is securely seated.
4. Connect to on the back of the
phone base, and then connect it to in the wall.
To connect to AC power
1. Connect to on the back of the
phone base, and then connect it to an AC power
outlet in the wall.
Note: is required for the phone to function
properly.
2. Connect to on the , and then
connect it to on the left side of the .
A dial tone indicates that the phone is properly
connected.
If you subscribe to DSL phone service
If you hear noise during conversations or if the
Caller ID function does not work properly, please
obtain and attach a DSL noise lter.
Attach the lter between the telephone cable and
the telephone communication jack in the wall.
To Next Page
Loading...
