English - 22 -
Controls
OSD Orientation
Sets the OSD (On Screen Display) rotation of your Display. LandscapePortrait 1
and
options are available.
Browser
Orientation
Sets the rotation of the browser. LandscapePortrait1 and Portrait2 options are
available. One of the portrait options will be set by default depending on the model.
This option will rotate the browser only and the changes will be applied after the
Note: Portrait mode does not support html pages which include videos.
Pixel shift
Enables or disables pixel shifting. This option can be used to avoid image retention
No Signal
set input source. Failover and Input Search options are available.
If Failover
is selected the Display checks the connected USB device for available
USB Auto
Play option in the Settings>System>More
will function anyway.
If Input Search
is selected the Display will search all available input sources
Signal OSD will be displayed and the signal search will continue according to the order
in the Sources list until the ANDROID source is reached as it will always be available.
How to install No Signal Image
menu and press OK.
No Signal Delay
If the No Signal
option is set as Input Search
No Signal Power
received from the selected source.
This feature will only work if all of the following circumstances occur:
- No Signal option is set as Failover.
- USB device is not connected to the Display / USB device is connected but there are
If the No Signal option is set as Input Search
Panel Lock
Set as to prohibit the use of the buttons on the Display.
RCU Inhibit
Set as On
to inhibit the use of the remote. Remote control will function in Stand-By
mode independently from the setting of this option.
MENU/M-1-9-7-3
buttons on the remote consecutively. Signage menu will appear. Enter the Controls
menu and set this option as
.
UART 0
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
the Display is booted up.
Note that ASCII/HEX selection is not working while debug logs are enabled. If it is
reboot the Display in order to correct the debug logs and the ASCII protocol behaviour.
Also note that HEX protocol will work with the baud rate value 19200 for UART 0.
To Next Page
Loading...
