English - 25 -
OPS Settings
Press OK to open the OPS Settings menu screen.
Three sub-menu options are
available.
OPS Information: Displays read-only information about the OPS unit, if supported.
OPS Status: Displays whether the OPS module is on or o. Allows the change of
status via soft PSON signal (0.5s)
Boot Signal: Enables or disables sending of a PSON signal. The Display checks the
status signal of the OPS at bootup in order to turn it on by sending a PSON signal if
it is o. Some OPS’s send incorrect information on their status during the bootup of
the Display, so they seem to be on even though they are o. For such non-standard
OPS’s, this option must be enabled. In this case, a PSON signal will be send for the
OPS regardless of the received status information at bootup.
Powerdown: Turns the OPS o via hard PSON signal (5s)
OPS Always on (optional): When this option is enabled, Quick Standby
forced to enabled and greyed out in the menu and OPS will not be set to standby.
Recovery Mode: When this option is enabled and OPS is on, if there is no video for 10
seconds it resets hotplug. If there is no video available after 30 seconds it reboots OPS.
Note: This menu will not be available if OPS is not supported or not connected to the unit.
Scheduler Settings
OK
to open the Scheduler Settings
the OK
OK
then use the directional and numeric buttons on the remote to set a time. Press the OK
button again when you are done.
Source tab for your scheduler option and press the OK
the Left/Right directional buttons. If the Source option is set as Last Source
source will not be changed at the power-up. If the Source option is set as USB
in the section entitled ‘USB Auto Play Feature.
the checkbox under the desired day tab and press OK to check. Highlight and press
OK a second time to uncheck a box. The scheduler will be active on the checked days
of the week.
OnSource
column and press OK
On value
valueOK
SourceLast Source
to the selected source only.
Press the Green
Link options
Press OK to open the link options menu screen. Current Start url and Settings url links
will be displayed. These items are for information only and not selectable. Refer to Usage
of the Start URL section for information on setting the Start url. Open browser initial
page and NTP server
Volume Settings
Press OK to see available menu options.
Reset to Default
Values
Highlight this option and press the OK
button on the remote to return the Display to
default settings.
First time installation
Highlight and press OK to perform First Time Installation and reset all settings to factory
settings. You will need to enter the correct PIN to carry out this operation.
Note: Enter the PIN you have dened during the First Time Installation process.
To Next Page
Loading...
