ClimateMaster iGate Connect - Service Mode

21
Humidity Control Settings
Con gures humidity control settings (dehumidi-
 cation/humidi cation).
Humidity Mode
Determines active humidity mode(s). Valid
selections: Humidi cation (This logic will
communicate a Humidi cation output when
the space humidity is less than the setpoint i.e.
acts as a humidistat. When the Humidi cation
output is active, the fan output will also be
active. The Humidi cation output will not be
communicated when the space humidity is
above the setpoint.), Dehumidi cation (This
logic will reduce the cooling air ow when the
space humidity is greater than the setpoint
to improve dehumidi cation i.e. acts as a
dehumidistat. The cooling air ow will not be
reduced when the space humidity is below the
setpoint.), Both, or None.
Service Mode
Unit – EXM Controller
Model Displays the unit model number
Serial Number Displays the unit serial
number
Manual Operation Manual Operation mode
allows the service technician to manually
command operation for any of the thermostat
outputs, blower speed, as well as pump
To con gure the
humidity control
settings on the iGate
™
Connect thermostat:
From the Home screen,
press MENU.
Select Settings ▶
Installation.
Select Humidity Control.
To con gure the service
mode on the iGate
™
Connect thermostat:
From the Home screen,
press MENU.
Select Settings ▶
Installation.
Select Service Mode.