12
STARTING UP THE SYSTEM
1. Plug the cigarette-lighter power plug into the cigarette lighter, this will also power on CAD15.
2. CAD15 will perform a Scan of DAB stations automatically.
3. Turn on your in-car audio system.
4. Enable the AF function on your car radio if it is equipped (Consult your car radio manual or the
car dealer if your car radio has AF feature, and how to enable AF feature).
5. Tune the car radio’s FM frequency to match to CAD15 FM TX frequency as shown on the screen.
Default is 87.6
6. If FM 87.6MHz is already used by a FM broadcaster or the station is noisy, change the initial FM
TX frequency as below:
a) Operating on CAD15
Press and hold LINK for 3 seconds, CAD15 will set a new and clear frequency to transmit
the FM signal.
b) Operating on Car Radio
Tune the car radio’s FM frequency to match to CAD15 FM TX frequency shown on the
LCD display screen; the CAD15 and the car radio are now synchronized.
7. If your car radio does not have AF feature, do the following to change CAD15’s LINKMODE to
AutoScan instead of the default AFC.
a) Press and hold MENU to enter the menu function.
b) Rotate the Rotary Knob [◄] [►] until the selection is《 Link Mode 》.
c) Press the Rotary Knob, and
then rotate the Rotary Knob [◄] [►] until the selection is
《 AUTOSCAN 》.
d) Press the Rotary Knob, the function of AutoScan is now enabled and the CAD15 is
operating in the AutoScan mode.
8. Now you can listen to the DAB stations. For the system operation, please refer to USING DAB
ADAPTER section.
9. While you are using AutoScan function and you are experiencing noise on the listening DAB
station, please refer to To Force Immediate FM Frequency Change or To Set FM Transmitting
Frequency Manually to force or manually switch to another FM frequency.
To Next Page
Loading...
Need help?
General