13
USING DAB ADAPTER
To Turn On or Set Standby Mode in CAD15
1. Press and hold the Rotary Knob to set to standby mode, while CAD15 is in the operating mode.
2. Press the Rotary Knob to return it to the operating mode, while CAD15 is in standby mode.
To Adjust LCD Brightness
1. Press and hold DIMMER to toggle the two LCD backlight brightness levels.
To Scan for the DAB Stations
This function searches and adds all DAB stations in Band III from channel frequency 5A to 13F that
are available in the area where your car is presently located.
1. Press and hold SCAN to do a full scan of DAB stations, the screen will show《 SCANNING 》.
To Listen to the DAB Stations
There are two options available for you to select and listen to a DAB station: Quick Tune and Step
Tune. Step Tune is used when you want to step through the station list one by one. Quick Tune
allows you to move more quickly through the station list.
Step Tune
1. Rotate the Rotary Knob [◄] [►], the screen will show the station list and the current selection.
Continue the rotation to step through the station list, one by one, and stop at the desired
station in the station list: 《 station name 》
2. Press the Rotary Knob to tune to the desired station.
Quick Tune
1. Accelerate rotating the Rotary Knob [◄] [►], the screen will show the station list and the
current selection. Each accelerated rotation will move through the alphabet sequence to the
first or last station of the next or previous initial letter in the alphabet from the current
selection, if the station list is sorted alphabetically; or move through the ensemble sequence if
the station is sorted by ensemble. Repeat the accelerated rotation, one alphabet at a time, or
one ensemble at a time, until the screen shows the DAB station with desired initial alphabet or
the desired ensemble.
2. Do the Step Tune to tune to the desired station.
To Change DLS/DL+ Information Display
The CAD15 provides certain information, in one or three lines on screen when enabled, about the
current listening station.
1. While the station information is being displayed, each time you press the Rotary Knob, the
screen will cycle through the four station’s information below
To Next Page
Loading...