EasyManuals Logo

Clint CAD15 User Manual

Clint CAD15
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
21
www.clintdigital.com
CAD15 User Guide
21
3. Then you can rotate the Rotary Knob [] [] until the screen shows YES or NO
4. Finally, press the Rotary Knob to confirm or cancel.
To Change the Link Mode
CAD15 can operate in one of the three link modes, AFC_H, AFC_L for AFC function, and AUTOSCAN.
By default CAD15 is set to use AFC_H mode; however, if you want to change to a different link mode,
do the following:
Setting on CAD15
1. In the menu function, rotate the Rotary Knob [] [] until the selection is Link Mode .
2. Press tthe Rotary Knob, and then rotate the RRotary Knob [] [] until the selection is
A FC_H , A FC_L , or AUTOSCAN .
3. Press the Rotary Knob to enable the selected CAD15 link mode.
Setting on Car Radio
1. For AFC_H or AFC_L mode, enable the Alternative Frequency feature of your car radio (consult
your car radio manual or the car dealer if your car radio has the AF feature, and how to enable
AF feature).
2. For AUTOSCAN mode, note the CAD15’s current FM transmitting frequency on the display and
manually change your car radio’s FM frequency to match to CAD15’s FM transmitting
frequency if they are out of sync.
To Set Auto Power Down Time
To avoid unnecessary draining of the car battery when CAD15 is idle, this Auto Power Down setting
will set CAD15 to standby mode..
1. In the menu function, rotate the Rotary Knob [] [] until the selection is
AutoPowerDown .
2. Press the Rotary Knob to enter Auto Power Down selection screen.
3.
Then you can rotate the Rotary Knob [] [] to select the desired time, the screen will show
options time where time is either OFF, 1, 2, 4 hours.
4. Finally, press the Rotary Knob to set this option for Auto Power Down.
To Set Antenna Power
For CAD15 to work with the active antenna, the antenna power must be set to ON. CAD15 can also
work with a passive antenna, you must set the antenna power to OFF.
1. In the menu function, rotate the Rotary Knob [] [] until the selection is Antenna
Power .
2. Press the Rotary Knob to enter Antenna Power selection operation.
3. Then you can rotate the Rotary Knob [] [] until the selection is
ON or OFF .

Other manuals for Clint CAD15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clint CAD15 and is the answer not in the manual?

Clint CAD15 Specifications

General IconGeneral
BrandClint
ModelCAD15
CategoryAdapter
LanguageEnglish