17
FM TRANSMITTING FREQUENCY SETTINGS
The FM transmitting frequency is used by CAD15 to transmit the audio and for car radio to
receive the audio. The FM transmitting frequency can be changed by the following:
1. Set FM transmitting frequency manually
2. Recall FM transmitting frequency saved in the memory
3. Force immediate FM transmitting frequency change
To Set FM Transmitting Frequency Manually
If you wish to change the setting and use your own selected FM transmitting frequency manually, do
the following:
1. Press LINK, and the screen will show the current FM Transmitting Frequency《 Frequency 》.
2. You can accelerate rotating the Rotary Knob [◄] [►] to step up or down FM frequency by 2MHz,
or just rotate the Rotary Knob [◄] [►] to step up or down FM frequency by 100KHz, to choose a
frequency until the desired FM frequency is displayed (e.g. 106.7MHz).
3. Then press the Rotary Knob, the CAD15 will set and transmit FM signal at this new frequency.
The screen will display the new frequency as the current frequency.
4. Press FM preset of your car radio corresponding to the same frequency from step 2 if you have
previously saved for DAB reception. Otherwise, tune the car radio to the same FM frequency.
5. Now you can listen to DAB stations via this new FM Frequency.
It is recommended to set the selected FM frequency as one of the memory presets of your car
radio, selecting this particular preset FM frequency and together with setting the CAD15’s FM
transmitting frequency will quickly enable you to start listening to DAB stations.
To Save a Desired FM Transmitting Frequency in Memory
It is suggested to save a few frequencies (up to 4 frequencies) in CAD15 so that you can switch to a
new FM transmitting frequency instantly when you drive into an area where the original FM
frequency for DAB is no longer available.
1. Press LINK, and the screen will show the current FM Transmitting Frequency《 Frequency
MHz 》.
2. You can accelerate rotating the Rotary Knob [◄] [►] to step up or down FM frequency by
2MHz, or just rotate the Rotary Knob [◄] [►] to step up or down FM frequency by 100KHz, to
choose a frequency, until the desired FM frequency is displayed (e.g. 106.7MHz).
3. Then press and hold a X control key
(where X is from 1 to 4) to save the current selected FM
frequency into the corresponding preset memory FX.
4. The screen will display a short message of 《 FX SAVED 》.
The default FM frequencies saved in presets F1 to F4 are 87.6MHz, 92.5MHz, 102.5MHz and
107.9MHz, respectively.
To Next Page
Loading...
Need help?
General