24
g) Switch CAD15 to Audio Streaming mode by pressing and holding MODE to listen to the
audio from your car radio.
2. Check the Aux in jack on the side panel of CAD15; ensure no audio cable is plugged in,
Q: I cannot hear Audio from the Auxiliary input
1. Check the setup and ensure the following:
a) Plug your audio cable for your audio device into the Aux in jack on the side panel of
CAD15.
b) Start playing the audio from your audio device.
c) Switch CAD15 to Audio Streaming mode by pressing and holding MODE to listen to the
audio from your car radio.
2. Check CAD15’s FM transmitting frequency (displays on the screen) and the car radio’s listening
FM frequency. If they are out of sync, tune the car radio’s FM frequency to match CAD15’s
FM transmitting frequency.
Q: I cannot re-connect to the held phone call automatically while in Hands Free mode
As there are different made of Smartphone, you might not be re-connected back to the held call
automatically on the following condition.
1. There are two calls in progress, one is active and one is on hold.
2. If the active call is hung up (by you or the destination); although CAD15 displays the held call
becomes active, but the actual call might be still on hold.
3. When this happens, try rotating the Rotary Knob [◄] [►] to return the held call to active. If
this does not work, please hang up and redial the held party.
Q: I hear echo or call volume is too low while in Hands Free mode
While the Hands Free call is in progress, if you experience the following conditions:
1. If the destination party hears echo, try turning down the volume of your Smartphone or the
car radio.
2. If you hear the call volume is too low, try turning up the volume of your Smartphone or the car
radio.
3. If the destination party indicates the call volume is too low, advise the destination party to
turn up the volume of his Smartphone or try turning up the volume of your Smartphone.
To Next Page
Loading...