CLIVET WiSAN-YME 1 S 8.1 User Manual

142
Control
9.19 Operation parameters
The OPERATION PARAMETERS menu is used by the installer or the technician
to check the operation parameters. The values shown on the pages are only indicative.
On the home page, select
MENU > OPERATION PARAMETERS
Press OK
The operation parameters are displayed on the following 9 pages.
Press Down, Up to scroll.
L
NOTE
The energy consumption parameter is calculated, not measured.
If a parameter is not available for the system, the corresponding value will be “--”
The heat pump capacity is indicative and should not be used as a measure of the unit's power.
The accuracy of the sensor is ± 1°C.
The flow-rate parameters are calculated according to the pump operation parameters, the deviation is
dierent at dierent flow-rates, the maximum deviation is 15%.
OPERATION PARAMETERS 1/9
ONLINE UNITS NUMBER 0
OPERATION MODE DHW
SV1 STATE OFF
SV2 STATE OFF
SV3 STATE OFF
PUMP_I OFF
OPERATION PARAMETERS 2/9
PUMP_0 OFF
PUMP_C OFF
PUMP_S OFF
PUMP_D OFF
PIPE BACKUP HEATER OFF
TANK BACKUP HEATER OFF
OPERATION PARAMETERS 3/9
GAS BOILER OFF
T1 LEAVING WATER TEMP. --°C
WATER FLOW 0.00M3/H
HEAT PUMP CAPACITY 0.00kW
POWER CONSUMPTION 0 kWh
Ta ROOM TEMP. --°C
OPERATION PARAMETERS 4/9
T5 DHW WATER TANK TEMP. 25°C
T 1B CIRCUIT2 WATER TEMP. --°C
T1S C1 CLIM.CURVE TEMP. 0°C
T IS2 C2 CLIM. CURVE TEMP. 0°C
TW_0 PLATE W-OUTLET TEMP. 0°C
TW_I PLATE W-INLET TEMP. 0°C
OPERATION PARAMETERS 5/9
Tbt1 BUFFERTANK_UP TEMP. 0°C
Tbt2 BUFFERTANK_LOW TEMP. 0°C
Tsolar 0°C
SOFTWARE IDU 00-00-2000V00
OPERATION PARAMETERS 6/9
ODU MOD. 0 kW
COMP.CURRENT 0 A
COMP.FREQUENCY 0 Hz
COMP. RUN TIME 0 MIN
COMP. TOTAL RUN TIME 0 HOURS
EXPANS.VALVE OPENING 0 P
OPERATION PARAMETERS 7/9
FAN SPEED 0 R/MIN
IDU TARGET FREQU. 0 Hz
FREQ.LIMITED TYPE 0
SUPPLY VOLTAGE 0V
DC GENERATRIX VOLTAGE 0V
DC GENERATRIX CURRENT 0A
OPERATION PARAMETERS 8/9
T W_0 PLATE W-OUTLET TEMP. 0°C
TW_I PLATE W-INLET TEMP. 0°C
T2 PLATE F-OUT TEMP. 25°C
T2B PLATE F-IN TEMP. --°C
T h COMP. SUCTION TEMP. 25°C
Tp COMP. DISCHARGE TEMP. 25°C
OPERATION PARAMETERS 9/9
T3 COIL F. TEMP. 25°C
T3 OUTDOOR AIR TEMP. 25°C
TF MODULE TEMP. 0°C
P1 COMP. PRESS. 0 kPa
ODU SOFTWARE 00-00-2000V00
HMI SOFTWARE 24-02-2021V67
Installer

CLIVET WiSAN-YME 1 S 8.1 Specifications

General

Brand	CLIVET
Model	WiSAN-YME 1 S 8.1
Category	Heat Pump
Language	English