CLIVET WSAN-XIN 21 - General Maintenance Guidelines; Inspection Frequency Recommendations

41
8 - MAINTENANCE
8.2 GENERAL
Maintenance must be done by authorized centres or by
qualified personnel
The maintenance enables:
• maintain the unit efficiency
• Reduce the deterioration speed to whom every equipment
is subject over time
• Assemble information and data to understand the state of
the unit efficiency and avoid possible damages
The inspections should be carried out at least every six months
The frequency, however, depends on the use .
In the event of frequent use it is recommended to plan
inspections at close intervals :
• frequent use (continuous or very intermittent use, near the
operating limits, etc)
• critical use (service necessary) .
8.3 INSPECTIONS FREQUENCY
G
C
B
D
A
F
A
Coil
Inverter
ELectrical panel
B
C
D
Exchanger
Circulator
Compressor
E
F
Fan
G
MAIN COMPONENTS
A
Vent
Output probe
Circulator
B
C
D
Safety valve ( 6 bar )
Plate exchanger
Flow switch
E
F
E
G
F
D
C
B
A
H
E
Input probe
G
Water discharge
H