CLIVET WSAT-XIN Series - Cascade Units; Remote Control; SA1 = on; Standby Remote; SA3 Second Setpoint Enabling Switch

22 WSAT-XIN 21-171 M0Q940G14-03
6.7 SA1 = On / Standby remote
Set parameter CL43:
Keys Esc + Set Menu PAr Menu CL
CL43 ON/OFF Standby Time bands only DHW
-1 from Menu: Fnc - St SA1 = remote standby NO from Menu: Operating mode
0 from Menu: Fnc - St from keypad: key DOWN YES from Menu: Operating mode
OFF: emergency stop, not active the antifreeze safeties etc.
Standby: assisted stop, are active the antifreeze safeties etc.
6.8 Remote control
For details see:
11 Accessoriesp.47
6.9 Serial communication module with RS485 serial converter kit
For details see:
11.2 CMSC2X - Serial communication module with RS485 serial converter kitp.48
6.10 SA3 Second setpoint enabling switch
For details see:
7.10 SA3: 2° set pointp.25
6.11 Cascade units
For details see:
11.3 KG4UP - Management kit up to 4 units in parallel by the two set point available for each unitp.49