Designated Use
This machine is intended for use engraving signs and other consumer products on applicable
substrates. This laser can process a wide variety of metals including steel, aluminum,
titanium, brass, copper, tungsten, carbide, and chrome. It can can also be used with stone
and some hard plastics such as acrylic. (See 2.5 & 4.3 for further details.) Use of this system
for non-designated purposes is not permitted.
The system must be operated, maintained, and repaired by personnel familiar with the field
of use and the dangers of the machine and the material being engraved including its
reflectivity, conductivity, potential for creating harmful or combustible fumes, etc.
Laser beams are dangerous. The manufacturer and/or seller bear(s) no responsibility and
assume(s) no liability for any improper use of this device or for any damage or injury arising
from such use. The operator is obliged to use this fiber laser marker only in accordance with
Caution!
Dangerous electrical voltage - indicates a risk of electric shock and warns
of imminent danger to the life and health of individuals or of significant
damage to equipment.
Caution!
Laser beam - means that the laser machine may operate in laser class 4
when commissioning the laser head. Warns of damage to eyes or skin
caused by direct or scattered radiation.
Important: Information the user must observe or know to avoid process
disruptions or malfunctions when using the product.
To Next Page
Loading...
Need help?
General
