CNC 6040 Router / Engraver System
CNCDIY CNC Routing Machines System User’s Manual
3
Reminder
z The machine uses a parallel interface and control computer connected through the parallel
port control software MACH3 controlled carving machine to run the various axes in
accordance with instructions, make sure you prepare for the routing machine control
computer has a parallel port, and the required work in EPP parallel port mode, any other
mode may result in engraving machine cannot operate normally, the EPP mode is set to be
carried out in the computer motherboard BIOS, all manufacturers to set methods vary, please
refer to the instructions to set up your computer. Part of the desktop computer does not have
built-in parallel port, users can be purchased parallel port PCI expansion card slot to use. But
any commercially available USB-parallel port adapter does not allow normal operation of the
machine
z Controlling the computer should be dedicated and, if possible do not install other
applications software; do not recommend the use of laptop computers to control the
engraving machine, part of the notebook computer's battery-saving chip may interfere with
the pulse signal, some parallel port voltage is low, may lead to pulse signal is lost the use of
engraving machine could not be properly controlled.
Warning
z The machine system is to rely on related software control, the need for the right software
settings in order to function properly, in the absence of fully recognized under the temerity to
set the correct test machine loaded knife can be dangerous or permanent damage to
machinery. During the software installation and settings, do not open the control box power
supply, in order to avoid malfunction causing damage.
z Do not at any time the power electronic control box connected to the case, pulling the plug
inserted above the line terminal; spindle power each time you open the speed control knob
must be transferred before the low-end office and then start-up; both spindle switch or driver
switches repetition interval of the switch at least once every 30 seconds or more; not pay
attention to the above questions is likely to cause some damage control circuits.
z As the use of the AC110V or AC220V voltage, power state, do not open the electronic
control cover, do not touch the spindle motor terminals, operation of the spindle motor driven
high-speed rotary cutting tool, do not touch, and a closer look at sculpture, the working must
be worn goggles or protective masks! The operator must wear a protective mask and a
goggle.
To Next Page
Loading...