COBHAM AVIATOR 200S - Page 6

Table of contents
vi 98-145168-A
4.3 Electrical installation and wiring ..........................................................................4-6
4.3.1 Wiring symbols .....................................................................................................................4-6
4.3.2 Wiring – overview ...............................................................................................................4-7
4.3.3 To wire the CSDU with AC input .................................................................................4-8
4.3.4 To wire the SCM ...............................................................................................................4-10
4.3.5 To wire the antenna ........................................................................................................4-10
4.3.6 To wire the SCDU 1, 2 and 3 ......................................................................................4-11
4.3.7 To wire the CMU 1 and 2 .............................................................................................4-11
4.3.8 To wire cockpit audio 1 and 2 ...................................................................................4-12
4.3.9 To wire IRS/GNSS .............................................................................................................4-13
4.3.10 To wire discrete inputs and outputs .......................................................................4-13
4.3.11 To wire airborne data loader ......................................................................................4-14
4.3.12 To wire fault/health reporting (CFDS) ....................................................................4-14
4.3.13 To wire Ethernet 1 (AISD#1 or EFB 1) ...................................................................4-15
4.3.14 To wire Ethernet 11 (AISD#2 or EFB2) .................................................................4-15
4.3.15 To wire Ethernet 3 (ADL in ACD) ..............................................................................4-16
4.3.16 To wire Ethernet 4 (ACD#1) .......................................................................................4-16
4.3.17 To wire Ethernet 5 (ACD #2) ......................................................................................4-17
4.3.18 To wire the Maintenance interfaces .......................................................................4-17
4.3.19 CSDU ARINC 600 connector block .........................................................................4-20
4.4 Recommended cables ................................................................................................4-28
4.4.1 Introduction .......................................................................................................................4-28
4.4.2 Allowed cable lengths for power cables ................................................................4-28
4.4.3 Recommended power cables .....................................................................................4-29
4.4.4 Recommended RF cables .............................................................................................4-29
4.4.5 Recommended cables for ARINC 429 ...................................................................4-29
4.4.6 Recommended cables for Ethernet .........................................................................4-29
4.4.7 Recommended cables for discrete signals ...........................................................4-29
4.4.8 Recommended cable between the SCM and the CSDU ...............................4-30
4.5 Verifying the installation .........................................................................................4-30
4.6 Activation of airtime services .............................................................................4-30
4.6.1 ID numbers for the AVIATOR 200S system ........................................................4-30
Chapter 5 Setup of the system
5.1 Software upload ................................................................................................................5-1
5.1.1 Overview ..................................................................................................................................5-1
5.1.2 Uploading software ............................................................................................................5-2
5.2 SATCOM system ready for use ..............................................................................5-2