List of events
98-175666-C Chapter F: Event messages F-14
0F002-0 BIMO ERROR BIM-O voltage
range
Voltage measured at BIM-O is not within
expected range
0F003-0 BIMO ERROR BIM-O cal data BIM-O calibration data is invalid
0F004-0 BIMO WARNING VMU reference
signal
There is no VMU Rx or Tx reference signal.
Whether this is Rx or Tx reference depends on
the user's selection on the modem profile page
in the web interface. Make sure the VMU Rx/Tx
cable is connected and that the VMU is
configured to output the RX/TX reference
signal.
0F005-0 BIMO WARNING No BIMO Master
PLL
BIMO Master PLL out of lock
0F006-0 BIMO WARNING No BIMO LO PLL BIMO LO PLL out of lock
ID Module Type Description Explanation
Table F-1: Event messages (Continued)