５-４-２ Screen Brightness/Contrast/Color/Saturation/Sharpen/Camera Adjustment
Select {Adjust}, then it becomes the 1 channel mode and a window pops up as shown below.
[Figure 5-20. Screen Setup Window]
Moving the camera, down, right, or left excessively may cause black or gray areas to appear on
the screen. The level at which such condition does not occur is the proper control range for the
camera.
５-４-３ Display Setting
Camera Title On/Off, Control Bar On/Off, Button Sound On/Off, Border Line Draw/Width/Color, Sequence
Duration 1-10seconds. After selecting Display Setting, it becomes the 1 channel mode and a menu pops up as
shown below.
[Figure 5-21. Display Setting Window]
To Next Page
Loading...
