６-７-１ DVR Name
. The initial value is the Mac address. (It supports up to 20 letters for the system name.))
６-７-２ ID for Remote Controller
When multiple devices are used, set the remote controller ID to identify input signals from the remote controller.
Only the system that DVR ID and remote controller ID match can receive input signals from
the remote controller as shown below.
① Move to {Menu} {Setup} {System} {2. Remote Controller ID}.
② In the selection window, enter ID by using the arrow keys and the Select button (the number 0~99
is available for ID.)
If you forget the DVR ID, set the remote controller ID to 999 to start the DVR. Note, however,
that the DVR ID should be the same as the remote controller ID.
※ To configure Remote Controller ID (Example: ID setting as 3)
1) Press {ID} button on the remote controller.
2) Press the {0} key and {3} key.
3) Press {ID} button again.
4) Remote Controller ID is set as 3.
６-７-３ ID For Keyboard Controller
③ Move to {Menu} {Setup} {System} {3. ID for Key Controller.
④ In the selection window, enter ID by using the arrow keys and the Select button (number 1~255 is
available for ID.)
６-７-４ User Registration
※ Add, edit, or delete the users who will operate the system and give authorities to users as shown below.
System Access Authorization
View the real-time images upon network access.
View the recorded images.
Recording, schedule, system, storage, Time, PTZ,
network, Screen setup
Covert channel monitoring
View the covert channel in the network.
Up to 15 users can be registered. Letters for ID and Password can be entered up
to 30.
６-７-５ Admin. Password
Setup the Administrator Password. The password can hold up to five digits.
To Next Page
Loading...
