Cobra Deluxe series - 6-2-5 Relay; 6-3 Recording; 6-3-1 Schedule Selection (Schedule1 ~ Schedule4); 6-3-2 Event

53
[Figure 6-46. Motion Area Setup]
① Select Motion Area of each channel.
② It becomes the 1 channel division mode and rectangular boxes appear where motions occur. Drag
the yellow pixel cursor by using the mouse or the front button/remote controller and select pixels w
here motion detection doesn’t applied. The selected area turns brown.
③ Select Exit to finish.
(2) Motion Sensitivity : Lowest/Low/Middle/High/Highest.
(3) Sound Sensitivity : Lowest/Low/Middle/High/Highest
(4) Sensor Type : Select the sensor type.
(5) EOL : EOL Function Select (On / Off).
.
６-２-５ Relay
Select the relay type.
６-３ Recording
The Main setup is to configure the environment of record and system and major functions.
In the real-time monitoring, move to {Menu}  {Setup}  {Recording}
[Figure 6-47. Setup / Recording]
６-３-１ Schedule Selection (Schedule1 ~ Schedule4)
① Each channel can be scheduled in 4 different schedules. This schedule can be set as the
recording schedule and each time can be 4 different schedules.
６-３-２ Event
This is to set the events On/Off of Motion / Sensor / Sound / Text Input / Text Search.
Recording
Type
Description
Continuous
Continuous recording based on the Normal Speed frame rate.
Motion
When motion is detected, recording will be initiated based on the event frame rate.
Sensor
When input signal from an external sensor is generated, recording will be initiated based on
the event frame value.
Sound
When audio is detected, recording will be initiated based on the event frame value.
Text Input
When a text is received from POS device, recording will be initiated based on the event frame
value.
Text
When searching Text, can select to receive email regarding the ‘Word’ that is set..