Status bar indicating information of the hourly
recorded image data and the speed.
Selecting the right-mouse button or menu button in the Playback Mode pops up the {Playback Menu} as shown
below.
[Figure 5-32. Playback Menu]
５-９-２ Smart Search
This function is used to search an image with the object movement at a specific zone quickly. Searching by each
channel and a detail control are available.
5 levels; Lowest / Low / Middle / High / Highest
Mosaic pixel control available between 1- 10
In the NTSC mode, search 30 frames once.
In the PAL mode, search 25 frames once.
① Move to the Smart Search and select the desired channel.
② After shifting to the 1 channel mode, select areas to be smart searched.
[Figure 5-33. Smart Search Area Designation]
③ The 14 * 15 pixel mosaic mode appears. In the beginning, all pixels are selected. Designate an a
rea by left-click and drag the pixel mosaic pointer(deep yellow). Designate another area by repeatin
g the same way.
It detects motions in non-designated blocks.
④ Right-click brings up the menu as shown below. Configure each category and press the Playback b
utton to start searching.
To Next Page
Loading...
