６-７-６ Upgrade
The firmware and menu setting of the product can be easily upgraded through the use of the external storage
devices or portable storage devices with USB 2.0 port.
※ Find and copy the upgrade file to the highest folder in the external storage device or portable
storage device supporting USB 2.0.
※ Connect the storage device with an upgrade file stored to USB 2.0 port at Right front panel.
1) After copying the upgrade file, be advised to get rid of the USB device with
safety removal mode from PC.
2) If the USB device is disconnected from the USB port while the upgrade file
is being copied, the DVR system may not automatically detect the file.
Removing USB during the upgrade in progress may cause damage on the
system.
The system starts over when the upgrade is completed.
(2) Firmware Upgrade
① Select {Firmware} and the upgrade file list stored in the selected device and simple version info of
the selected file are then displayed. Select a file and Firmware Upgrade window appears.
[Figure 6-56. Firmware Upgrade Progressing Window]
※ Downgrading to a previous version is not supported.
※ The upgrade information window will then appear within 15 seconds.
② Read the information and select {Yes} to start the upgrade gradually. Select {No} to return to the
{System} mode.
③ After the upgrade is completed, the system reboots.
④ Move to {Menu} {Miscellaneous} {DVR Information} {3. Software Version} to check the
version.
(3) Setup Upgrade
① Select {Setup} and the upgrade file list stored in the selected device and simple version info of
the selected file are then displayed.
② Select a file and then the upgrade starts immediately.
Select a file and then the upgrade starts immediately. All setting values of the
current menu will be changed to the upgrade setting values.
To Next Page
Loading...
