Compliance
100 NGT Transceiver Getting Started Guide
FCC compliance
FCC Part 90 certification
The NGT SR Transceiver has been tested and certified to FCC
Part 90 (FCC identifier code DYYNGT-3).
The NGT VR Transceiver has been tested and certified to FCC
Part 90 (FCC identifier code DYYNGT-11).
FCC Part 15 compliance
Any modifications made to the NGT SR and VR Transceiver
and 3020 Transceiver Supply that are not approved by the
party responsible for compliance may void your equipment’s
compliance under Part 15 of the FCC rules.
The NGT SR and VR Transceiver and 3020 Transceiver
Supply have been tested and found to comply with the limits
for a Class B device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by switching
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and
receiver
• connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician
for help
To Next Page
Loading...
Need help?
General
