Entering and editing text
64 NGT Transceiver Getting Started Guide
Inserting text
To insert text:
1 Use or to move the cursor to the point where you
want to insert text (or a space), then press the required
character key.
Deleting text
To delete text:
1 Use or to move the cursor one position to the right
of the character that you want to delete, then press .
Saving text changes
To save the changes you have made:
1 Press .
The question mark is removed from the heading.
If you do not want to save the text, hold to discard the
changes.
NOTE
If you want to insert a space, make sure
that A or a is displayed at the bottom right
of the screen before you press 0, otherwise
you will enter a zero.
NOTE
You can enter a special character using
*
,
or with and .
To Next Page
Loading...
Need help?
General
