NGT Transceiver Getting Started Guide 65
Appendix B Using Quick Start
Quick Start provides simple methods to configure your
transceiver to a basic operating state.
Quick Start is available if your transceiver has not been
programmed with a profile, or contains only one station self
address and network names from this default list:
•*Voice
• *Selcall
•*CALM
• !Default
Opening and closing Quick Start
To open Quick Start:
1 Hold .
To close Quick Start:
1 Press or hold .
NOTE
When you hold , you should see the Quick
Start entries, for example, Add/Edit channel,
Set scan list etc. If these entries are not
displayed, then Quick Start is not available to
you.
In countries that do not permit programming of
transmit frequencies using the handset, you are
not able to add channels using Quick Start; this
is achieved using NSP.
For detailed information on programming your
transceiver without Quick Start see the
reference material on the enclosed CD.
To Next Page
Loading...
Need help?
General
