Code 2600 User Manual

C007964_01_CR2600_User_Manual
6.0 - Establishing a Bluetooth® Connecon
4
2. Scan the QuickConnect Code located on the front of the Charging Staon with embedded CodeXML® modem or on the external
CodeXML® M3 Modem. For additonal CodeXML® M3 Modem conguraon informaon, please reference the CodeXML® M3
Modem QuickStart Guide.
3. The wireless icon located at the top of the reader will ash as it aempts to make connecon. The blue LED on the charging
staon or CodeXML® M3 Modem will also ash as it aempts to connect. The blue LED will turn on when connecon is estab-
lished, the CR2600 will beep once and the wireless icon will ash every 10 seconds.
Important Note If Using a non-Code Bluetooth Device:
To connect to a Bluetooth device not manufactured by Code, you will need the Bluetooth address (oen referred to as the
BD_ADDR) of that device. The 12-character Bluetooth address can be found on the device near the serial number. Then visit Code’s
website at: hp://www.codecorp.com/bdaddr.php and enter the 12-character address to create the QuickConnect Code.
You will need to locate the Communicaons (COM) Port assigned to the Bluetooth serial port protocol before installing the
Bluetooth Conguraon Manager soware that is included with your Bluetooth adapter (e.g., COM 10). This is the COM Port
through which the CR2600 will connect.
QuickConnect Code
Blue LED
Blue LED
Wireless
Icon
Storage Icon
Good Read
Indicator
1. If establishing a Bluetooth connecon using the Charging Staon with embedded CodeXML® Modem, slide the Communicaon
Mode Switch on the Charger/Modem Staon, to Bluetooth mode (the direcon of the arrow).
Communicaon
Mode Switch
7.0 - Communicang in USB Mode
2. CortexTools™ will need to be installed to your host device for opmal communicaon performance during data transmission.
For CortexTools™ support, please contact Applicaon Engineering at Code appeng@codecorp.com.
1. For reader to communicate in USB mode using the charging staon with embedded CodeXML® Modem and CortexTools™, scan
the following USB Downloader Mode conguraon code:

Code 2600 Specifications

General

Operating Temperature	0°C to 50°C (32°F to 122°F)
Voltage	5 VDC ± 10%
Resolution	4 mil
Interface	USB, RS232, Keyboard Wedge
Supported Barcodes	Code 39, Code 128, UPC/EAN, Interleaved 2 of 5, Codabar, MSI
Humidity	5% to 95% (non-condensing)