Code Reader 1200 User Manaul

C001537_15_CR2_User_Manual 36
Save Settings
2.11.1 - Continuous Scan - Sleep Time Out
Scan one of the codes below to set the amount of time a cabled CR2 will operate in continuous scan mode before entering
sleep mode:
Cabled - 2 hours Cabled - Always (Default)
Scan one of the codes below to set the amount of time an uncabled CR2 will operate in continuous scan mode before
entering sleep mode:
Uncabled - 5 minutes (Default) Uncabled - 15 Minutes Uncabled - 30 Minutes
Note: This function is only recommended for short term use because of battery consumption.
2.11.2 - Continuous Scan - Trigger Delays
Scan the following codes to set delay time between scans:
0 Seconds (Default) 1 Second 3 Seconds
2.11.3 - Continuous Scan - Duplicate Scan Delay
Scan the following codes to set the delay time for reading duplicate codes:
0 Seconds (Default) 1 Second 3 Seconds
2.11 - Continuous Scan Settings
2.12 - Motion Detection Scan Settings
Scan the following codes to set the reader to read when it detects motion in its scanning zone.
On Off (Default)

Code Reader 1200 Specifications

General

Brand	Code
Model	Reader 1200
Category	Barcode Reader
Language	English