3. Place the label media and hubs in the media guides.
4. Adjust the media guides. Label media should be secure but still able to turn freely.
5. Place the label media below the media guides and into the feeder slot.
6. Feed the label media until the SLS automatically feeds it through the media path.
You might need to hold the label media in place for a few seconds.
NOTE: If the SLS fails to feed the label media, open the front cover, press the Unload button,
remove the media from the media path, wait until the media path rollers stop spinning, and try
loading the media again.
7. Close the rear cover.
Login
To Next Page
Loading...