Codonics Safe Label System SLS 550i - Installing Update Packages

7. If portions of the label media are still jammed in the media path, power off the system (refer
to “Shutdown and Power Off”). Use non-metallic tweezers and carefully remove any
additional label media from the media path.
8. Press the Unload button to reverse any portion of the label media that is still in the media
path.
9. Inspect the label media. Use scissors to cut off any damaged labels.
10. Close the front cover, load the label media, and close the rear cover.
Installing Update Packages
Use this procedure to manually install formulary update packages and configuration update
packages.
NOTE: Formulary and configuration update packages can also be installed remotely using the
Administration Tool. For more information, refer to the SLS Administration Tool User’s Manual
v1.3.0.
CAUTION: Installing system software should only be performed as directed by Codonics
Technical Support. Do not attempt to install system software without the assistance of Codonics
Technical Support.
1. Log in.
2. Make sure that the SLS is not processing any print jobs or utilities.