Coffee Queen A-2 - Cater Machine Programming

FILTERBREW & SERVING CONCEPT
10
PROGRAMMING
ADJUST DISPLAY
+5°C
5
+4°C 4
+3°C 3
+2°C 2
+1°C 1
0 0
-1°C -1
-2°C -2
-3°C -3
-4°C -4
-5°C -5
Cater
Adjusting of water temperature
Normal operation with reduced outlet time
Press buttons and at the same time for 5 seconds until you
hear one beep. Display shows the present setting
Adjust with the buttons = (increase) and = (decrease).
Confirm the new settings by pressing the button.
70°
0
C = min. temperature.
96°
0
C = max. temperature.
This mode is entered by pressing the and before turning the
mains switch on. The buzzer gives a 5s beep to indicate this mode.
This machine operates like in normal mode but the outlet times are reduced by
90% in order to allow faster adjustment of valve times.
Adjusting of temperature sensor
In this mode a temperature offset for the NTC sensor can be adjusted.
The procedure to enter this mode is the following:
Press buttons , and at the same time for 5
seconds until you hear 2 beeps.
The display shows the current setting.
Adjust with the buttons = (increase) and = (decrease).
Pressing the button to save new settings and return to normal
mode.