Page 18 800 Series
Reading Audit Information
Single-/Four-Price and Protocol A Models Only
By reading Audit Information, you can gain
valuable information about your vendor’s
performance. Audit information is retrieved via
the Digital Display by performing the following
steps:
1. Enter the Display Mode (see “Display
Mode” section of this manual).
2. Press C. In response, the display will show
Address “d000”.
3. Press B or D to scroll to the desired audit
address (see Audit Information Addresses).
4. Press C to view the upper four digits of the
displayed address. Press C again to view the
lower four digits, including the decimal point
(if any). EXAMPLE: 10,480.20 would be
displayed as 0104 in the upper four digits
followed by 80.20 in the lower four digits.
5. Press C again to return to the Address
Display.
6. Press A to exit to the “FULL/FILL AbCd”
message.
NOTE: Audit Information is “read only” it can
only be reset using Coinco Support software. or
if address C049 is enabled (Use address C050
to clear audit data)
NOTE: Free vends issued directly from the
vending machine are not audited by the
changer.
SECTION 3: CONFIGURATION
Tube Counts
By briefly depressing and releasing an inventory
button, you can obtain information about the coin
value and the quantity of coins within the tube.
To Next Page
Loading...
