Coinco GLOBAL2 - Troubleshooting Guide

Page 29
800 Series
SECTION 5: TROUBLESHOOTING
Troubleshooting Guide
TROUBLE POSSIBLE CAUSE PROCEDURE REMEDY
No coin acceptance No power Make sure changer Plug changer into
is plugged into vendor. into vendor.
Acceptor Check power/blocker LED Replace acceptor.
behind acceptor. (Four Price Only.)
If LED is on, replace acceptor.
If still no coin acceptance, Replace changer’s
main logic board.
If still no coin acceptance, Replace changer’s
main power harness.
If LED is off, check to see Plug acceptor cable and/or
that acceptor cable and changer changer power harness
power harness are properly into changer main logic
connected to changer’s board.
main logic board.
If still no coin acceptance, Replace changer’s
main logic board.
If still no coin acceptance, Replace changer’s
main power harness.
Low Power. Flashes “20” on display when coin Check power source.
is dropped.
Vend price is set to 0. Set vend price (see “Setting the Vend
Price” sections of this manual.
No Coin Acceptance Coin Return Lever Make sure changer is mounted Reposition changer and/or
or Rejects Percentage correctly and coin return lever vendor coin return lever.
of Good Coins is in proper position
Acceptor is dirty or foreign Check to see that acceptor coin Clean acceptor and remove
matter in coin accept path path is clean and free of matter any foreign matter.
If still rejects good coins, Replace acceptor.
If still rejects good coins, Replace changer’s main
logic board .
Accepts Coins But Acceptor Replace acceptor with good Replace defective acceptor.
Gives No/Or Erratic acceptor and test to see if
Credit changer functions properly.
If still no/erratic credit, Replace changer’s main
logic board.
If still no/erratic credit, Replace changer’s main
power harness.