Coldelite LB-100B - Product Too Soft; Product Too Hard; Machine Will Not Freeze

5) Compressor will
not st art
a) Low line voltage
b) Open starting
capacitor. Relay contacts
not closing
C) Off on high pressure
a) Check power supply
voltage, Determine
voltage drop
b) Replace start capacitor.
Replace defective relay.
c) Clean condenser.
Refrigerant over-charge.
6) Compressor operates a) Shortage of refrigerant
long or continuously
b) Dirty condenser
. .
c) Location 'too warm
a] Repair leak and
recharge
b) Clean condenser
C) Change to cooler
location
7) Burnt rubber a) Product in cylinder .' a) Refer to H.0.M-
odor frozen too hard adjustment
b) Drive belt slipping b) Tighten belt
8) Mix dripping from
dispense head
a) Damaged or worn O-ring
a) Replace suspect
o-ring
9) Mix dripping. from side a) Damaged or worn beater a) Replace beater seal
overflow drip tray seal
PACE 19