C)
DRIVE
SYSTEM
The rotation of the beater
is
counter clockwisz and is motivated
by
a
belt
drive system,
PART
IX
MAINTENANCE
Your COLDELITE machine has been designed, engineered and manufactured to
achieve high performance and long durability.
The life expectancy of
a
machine, any machine, does not depend only on the
quality of
its
components and design, but also on the beneficial effec~s of
basic procedures.
It is important to you, therefore, to become familiar with a
kw
of these
basic procedures:
.
.
"t
-
..
--:.-:,
%
?:>'-*
,.
h
.:.-.v.*-:
J..
--
..,.
;
.
-
.
-3
Remove
'0'
rings only
with
the
'0'
ring extractor supplied wlth
the machine.
Clean the machine according to the instructions,+
.
=
-
.
G,-s.,r.
.
..
-
-:_
-
=_
-
Lubricate all
'0'
rings and seals, as instructed,
The wearing or the improper cleaning of the beater shaft seal, will
resul
t
in leakage from the rear- Check the drip tray frequently and
replace the seal when necessary.
Replace any
'0'
ring that has a nick
in
it,
If
not replaced,
it
will leak
and interfere with the proper performance of the machine.
When all the spare parts supplied with the machine are used, re-order
immediately. Do not wait until the part is required again-
NEVER use the AUTO position for washing, sanitizing and
initially
filling the freezing cylinder.
IMPORTANT
-
During the washing and sanitizing period, run the machine
only for time strictly necessary for this operation. Prolonged use of the
beater in the Cleaning position may causcl severe damage to the machine.
Always wash metal, plastic or rubber parts
in
lukewarm water. NEVER,
NEVER USE HOT VJATEil!
IMPORTANT
As the model
LB-1008
is
an air cooled machine, its efficiency depends on the
air cooled condenser. The fins of the condenser must be cleaned every two
or three months to assure efficiency.
WARNING
.-
Extreme care must be taken when removing side, rear or control box panels.
Always turn the Se1ec;or Switch ro the OFF position. Also, turn off the
Disconnect Switch on ihe eleca-iczl supply line before exposing any
electrical connections
and/or moving parts, such as belts, pulleys, fan
blades and beater.
PAGE
17
To Next Page
Loading...
