fie
mode1
LB-1008
requires a
11
5
Volt,
60
Hertz
dedicated
circuit
[
no
other electrical appliances on the circuit),
X
separate circuit breaker
rated
at
30
AMPS
is required
.
.
.
-
ADEQUATE
WIRING
must
be provided with respect to wire size or gauge.
This includes the direct power line to the madnine electrical and connection
box,
Coldelite batch Creezers are equipped *:4ith proteciion for the beater motor.
Should the line voltage crop, or
in
:he unIikely event a shori circuit occcrs,
the overioad protector
will
automatically disconnect :he contactor. This
wiII stop :he machine immediately so that no permanent damage
will
be caused to the motor.
To resiart the freezer, depress the reset button which is accessible throu~h
an opwing at the lower right cornlr of the risnt
sic2
panel. The protector
must cool for several minutes before the reset will operate (Ref. Fig.
2).
The compressor is internally protected-
If
the Xlixon proteGor trips
due to
an
overload condition, the compressor
wil!
stop and auionaiicalIy
restzfl once ihe protector has cooled for several minutes.
01
ELECTRICAL
CONNECTIONS
(REF.
FIG.
51,
Haviq removed
;he
riskit
side
?ace!,
ih~
machine's t!ec;rica[ cornponencl
wirins c3nnec:ion box ctn be
located
az
the
lower righr corner. ?=move
the itleca-ical connection Sox cover.
-.
I
ne
?owe? !ine
is
first ,passed :hroush zhs ac<=si hole iocactd a< the bottom
right :oar of the machine. The tine
is
?ken ~assed upward thrcugh
tkt
SCC~~S
hole in the 3ol?om
dack
z'ir=c!:/ ixo
:he
c!ec;rical c3r,nec;ion box,
The
power iins ,nay now be cannec;td
;O
i=rminab
Li
and
LZ.
Us2
aaproprizce
elec~rical wiring hardware and cocneciors
as
governed
5y
ele~rical
codes.
In all installations, the machine
MUST
be
properly grounded. Adequate
ground continuity
is
assured by runnjng and securely fastening
a
ground
line (conductor) to
the
ground lug located in :he electrical connection box,
UTTO
To Next Page
Loading...
