7.
Wash all parts in luke-warm water
(80°-8S°F)
using a mild
detergent and the cleaning brush provided in the START-
UP KIT.
DO NOT USE HOT WATER FOR PROCESSING
ANY
OF THE PLASTIC PARTS
AS
DAMAGE TO THE PARTS CAN RESULT.
Rinse the parts in luke-warm water
(80°-ilS°F).
Place the parts in luke-warm water, containing sanitizer, for
2
to
5
minutes. Use the sample sanitizer provided in the STXRT-
UP
i<
IT following the manufacturer's directions.
Arrange the parts on a clean, sanitized counter area and allow
to air dry or reassemble wet if desired. DO NOT T,'3WEL
DRY
OR RINSE THE SANITIZED PARTS.
The cylinder walls musi also be washed and rinsed using luke-
warm water
(80°-8S°F),
mild detergent, and followed by
wiping with sanitized water. Allow cylinder to air dry or
reassemble wet.
PART
IV
ASSEMBLING THE FREEZER
Once the cylinder and parts have been washed, rinsed and sanitized, the
freezer is ready to be re-assembled. Prior to beginning the re-assembly
procedure, sanitize your hands by submerqing in sanitizing solution. Re-
assemble as follows:
PACE
10
To Next Page
Loading...
