Colorlight X2s - Sending Device Settings

6
2.3.1 Sending Device Settings
The setting of sending device contains three aspects: Video Source Settings, Control
Area and Other.
1.Video Source Settings
① Signal Source Selection
When the input of signal source of the X4s controller is normal, the information of input
signals obtained by the software can be displayed in the upper-right corner of the Video
Source Settings page. You can select a specified signal source（HDMI/DVI1/DVI2）based
on your own need in the upper-left corner of the page, and then the selected signal source
will be displayed in the canvas area.