14
WORK
1. PREPARING TO WORK
1. Carry out the operations for the preparation of the machine
2. Connect the connector to the batteries (1)
3. Check that the parking brake is released (2)
4. Turn the key of the general switch (3) clockwise of a quarter turn. Immediately, the general green
signal lamp comes on (4) and the digital display indicates the charge level of the batteries
2
3
4
ON / OFF
5. Press the brushes motor switch (1)
6. Press the suction motor switch (2)
Note
The machines with automatic version have the functioning of the suction motor only during
forward motion
7. Press the solenoid valve switch (3) (only in the automatic versions)
8. Adjust the amount of detergent solution through the cock lever (4)
3
2
1
4
9. Push forward and lift the control lever to lower the brushes base and to adjust its pressure onto the
floor (1). In case of machines with actuator, lower the lever button (2) until the yellow lamp comes off
(3)
10. Lower the squeegee acting upon the lever (4)
Note
For the automatic versions see further on in the paragraph “SQUEEGEE AUTOMATIC MANUAL”
1
2
3
4
11. Pushing forward the lever on the handle bar, the machine begins to move. During the first metres of
operating, check that the brushes pressure is suitable (see further on under “BRUSHES
PRESSURE”), that the quantity of the detergent solution is sufficient and that the squeegee dries
perfectly.
The machine will now start working efficiently until the detergent solution runs out.
To Next Page
