16
WORK
5. TRACTION
These machines are equipped with electronically commanded traction, and continuous speed variation.
To move the machine, rotate the key into position ON, wait for three seconds and then push forwards
(forward movement) or backwards (rear movement) the lever placed on the handle bar.
For safety reasons, in reverse motion, the speed movement is reduced.
ATTENTION! When carrying out even short backward movements, make sure
that the squeegee is lifted.
6. BRAKES
The machine is equipped with two braking systems: a working brake controlled by the lever on the rear left
side (2) and a parking and emergency brake controlled by the lever placed on the rear right side (1).
Lower the levers to operate the brakes.
The lever of the emergency brake is equipped with a blocking device. To release this brake, press the
trigger placed on the lever (1) itself.
7. DEVICE TOO FULL
The machine is equipped with a float, which intervenes when the recovery tank is full. Its intervention
causes the closing of the suction hose. In this case, it is necessary to proceed with the emptying of the
recovery tank taking off the plug of the exhaust hose.
8. RECYCLING OF THE CLEANING SOLUTION
If the machine is equipped with a recycling system of the cleaning solution, for its use refer to the
instructions given with the device. In any case, it is necessary to pay attention to the following
recommendations:
1. the use of the recycling system must be limited to the cleaning of environments not excessively dirty
2. avoid absolutely to treat environments not homogeneous for use and typology of dirt or anyhow
separated between each other
3. normally, the treated surface does not have to exceed twice as much of the one treated without
recycling
4. remember that the detergent efficacy progressively gets exhausted and it is absolutely not
recommended to make additions in the dirty solution
5. clean thorou
hl
the filters and the tanks at the end of the work
To Next Page
Loading...
