ComAp IG-NTC GC User Manual

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
214
NOTE:
See an example in the description of the binary input Force value 1.
Binary input: Force block 1
Related FW
3.0
Description
This is one of three binary inputs used for user-defined blocking of protections. If
the input is active, all the protections that have Protection block type configured as
Force block 1 block type are blocked (i.e. temporarily disabled).
Binary input: Force block 2
Related FW
3.0
Description
This is one of three binary inputs used for user-defined blocking of protections. If
the input is active, all the protections that have Protection block type configured as
Force block 2 block type are blocked (i.e. temporarily disabled).
Binary input: Force block 3
Related FW
3.0
Description
This is one of three binary inputs used for user-defined blocking of protections. If
the input is active, all the protections that have Protection block type configured as
Force block 3 block type are blocked (i.e. temporarily disabled).
Binary input: Lang sel int A
Related FW
3.0
Description
This is one of three binary inputs Lang sel int A, Lang sel int B, Lang sel int C,
used for selecting language of the built-in IG-NT terminal (display). As the IS-NT
does not have built-in terminal, this input is assigned to the terminal (display) #1,
which is supposed to be directly attached to the controller or mounted close to it.
NOTE:
Using these inputs for language selection is an option only. If the inputs are not
configured, the language can be selected using the menus on the terminal.
ENCODING TABLE
LANGUAGE INDEX
INPUT A
INPUT B
INPUT C
0
0
0
0
1
1
0
0
2
0
1
0
3
1
1
0
4
0
0
1
5
1
0
1

ComAp IG-NTC GC Specifications

General

Brand	ComAp
Model	IG-NTC GC
Category	Controller
Language	English