InteliLite
NT
– MRS3,4, AMF8,9, SW version 1.4, ©ComAp – October 2008 48
IL-NT-MRS3,4-AMF8,9-1.4-Reference Guide.pdf
Events specification
Protection
type
Information on binary
output available (See
list of Binary outputs)
Description
parameter. The controller stays in
INIT mode. Check all parameters,
write at least one new parameter.
Fgen < SD YES The generator frequency is below limit
given by 75% of Nominal freq
setpoint.
Overspeed SD NO The protection comes active if the
speed is greater than 115% of value
equal to 30*Nominal freq. setpoint.
Underspeed SD YES During starting of the engine when the
RPM reaches the value of Starting
RPM(= 25% of Nominal RPM)
setpoint the starter is switched off and
the speed of the engine can drop
under Start RPM again. Then the
Underspeed protection becomes
active. Protection evaluation starts 5
seconds after reaching StartingRPM.
EmergencyStop SD NO If the input Emergency Stop is opened
shutdown is immediately activated.
Stop Failed SD YES Gen-set stop failed.
ChargeAlt Fail WRN YES Failure of alternator for charging the
battery.
Wrn ECU Alarm WRN NO *ECU alarm list is not empty
To Next Page
Loading...
