ComAp IL-NT MRS15 - Controller Description and Features; General Description of the Controller System; Package Contents

InteliLite
NT
– MRS3,4, AMF8,9, SW version 1.4, ©ComAp – October 2008 6
IL-NT-MRS3,4-AMF8,9-1.4-Reference Guide.pdf
General Description
Description of the controller system (with all options)
InteliLite
NT
MRS3/4, AMF8/9 is a comprehensive AMF-controller for single generating sets and sets
operating in stand-by mode. IL-NT AMF9 features extended support of electronic engines.
InteliLite
NT
controllers are equipped with a powerful graphic display showing icons, symbols and bar-
graphs for intuitive operation, which sets, together with high functionality, new standards in Gen-set
controls.
InteliLite
NT
automatically starts the Gen-set, closes the Gen-set C.B. when all conditions are met, then
stops the engine on external signal or by pressing push buttons.
Gen-set C.B. is controlled by binary output but works without feedback signal. Mains C.B. works
similary.
InteliLite
NT
provides gas engine support without ventilation.
The key feature of InteliLite
NT
is its easy-to-use operation and installation. Predefined configurations
for typical applications are available as well as user-defined configurations for special applications.
Software and Hardware Compatibility
It is possible to use HW from higher type of controller for SW of lower type of controller. The table
below describes software and hardware compatibility.
Software Compatible Hardware
IL-NT MRS3 IL-NT MRS10
IL-NT MRS4 IL-NT MRS15
IL-NT AMF8 IL-NT AMF20
all IL-NT AMF/MRS IL-NT AMF25
What is in the package?
Accessories Description Optional / Obligatory
IL-NT AMF/MRS InteliLite
NT
central unit Obligatory
IL-NT-RS232 RS232 communication card Optional
IL-NT-RS232-485 RS232 and RS485 communication card Optional
IL-NT-S-USB S-USB service USB card Optional
IL-NT AOUT8 Gauge driver card Optional
**IL-NT RD Remote display software Optional
AT -LINK-CONV Service programming RS232 interface Optional
**Remote display for IL-NT controllers uses standard IL-NT controller with Remote
display software.
Extension modules
IGL-RA15 - Remote annunciator and IG-IOM/PTM - I/O extension module are
not supported in IL-NT MRS3/4 and IL-NT AMF8/9.
Hint:
For detailed information about extension modules used with IL-NT controllers, please see the IL-NT-
Accessory Modules manual.