InteliLite
NT
– MRS3,4, AMF8,9, SW version 1.4, ©ComAp – October 2008 13
IL-NT-MRS3,4-AMF8,9-1.4-Reference Guide.pdf
Typical wiring
IL-NT RD Remote display software
IL-NT RD is remote display software for a controller. Remote display provides the same control and
monitoring functions as controller itself. Remote display for IL-NT controllers uses standard IL-NT
controller with Remote display software. No further programing of the display is required – unit is self
configurable from the main controller. It is connected with the controller via IL-NT-RS232
communication modules using RS232 line. Longer distances (up to 1200m) are possible using IL-NT-
RS232-485 communication module or when RS232/RS485 converters are used.
The IL-NT RD hardware type should fit to the master IL-NT.
Hint:
Please see the “IL-NT-RD Remote display software” chapter for more details.
IG-IB Internet bridge
IG-IB Internet bridge enables InteliLite
NT
for Ethernet/Internet communicatons. It is connected to
controller via RS232 line.
See the InteliCommunication guide for further details.
To Next Page
Loading...
