ComAp InteliGen - Page 40

Setpoint edit
Leave setpoint edit without changes
History screen
Go to Menu screen
FastEdit screen
Fast edit exit (to previous measurement
screen) without changes
Language screen
Language screen exit (to menu) without
save
Table of characters
Jump among table of characters, menu
and text line
13. ↑ Select the setpoint, setpoint group, select the screen, select history record,
increase setpoint value, edit stringlist value, select language
14. ↓ Select the setpoint, setpoint group, select the screen, select history record,
decrease setpoint value, edit stringlist value, select language
15. → In AlarmList screen, shift the Alarm list page down (if more than 7 items),
moves history record displayed columns to the right
16. ← In AlarmList screen, shift the Alarm list page up (if more than 7 items),
moves history record displayed columns to the left, go to Info screen
17. Enter Same as 3.
18. Alarm list Shortcut to Alarm list screen from any other screen
19. History Shortcut to History screen from any other screen
Pushbuttons’ combinations
Following table determines controller functions when ↑, ↓, ←, →, ENTER and
PAGE buttons’ combination is pressed:
Where
Pushbutton
combination
Function
Measurement
screens, Alarm list
ENTER + ↑
ENTER + ↓
ENTER + ESC
Contrast increase
Contrast decrease
Info screen
Info screen
ENTER + ↑
ENTER +
↓
Backlight increase
Backlight decrease
History screen
number + ENTER
Go to record with this number
LEDs:
20. Mains status LED
21. MCB status LED
22. Load status LED
23. GCB status LED
24. Gen-set status LED
InteliVision 5, InteliVision 8 – Operator guide, ©ComAp – January 2014
IGS-NT Operator Guide 01-2014.pdf
40