InteliPro, SW version 1.4, ©ComAp – April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
Binary inputs
The binary inputs of the unit are used to receive basic information about the installation site, its
operational state and conditions. They can be also used for control of the unit operation, i.e. blocking
of protective functions, induce tripping by binary signals or providing remote fault reset signal.
To wire the binary inputs correctly, please use the following picture. The black line is to be wired to the
unit, the blue line indicates internal arrangement of the unit. Use min. 1 mm
2
cables for wiring of binary
inputs.
NOTE:
The name and function or alarm type for each binary input have to be assigned during the
configuration.
WIRING OF BINARY INPUTS
To Next Page
Loading...
