User Interface
Control and navigation pushbuttons - basic operation
General operation using buttons:
In the measurement screens, use the and , arrow buttons to browse through the
measured values as displayed on the graphical display. See the chapter Measurement
screens to get the basic orientation.
Use the button to cycle through display of measurement screens, adjust setpoints and
view the history table. For setpoints change, see the following chapter.
To enter the init screen, change language or read the list of unlocked InteliPro options, push
the and buttons at the same time. Together with the init screen display, the unit
performs lamp test by simultaneous blinking of all LEDs.
For confirmation of change any setpoint, use the button.
Passwords
InteliPro provides 3 levels of password protection. The system of passwords allows to assign different
levels of password to different personnel groups. After entering of the password of 1
st
or 2
nd
level, it is
possible to change that password or the password of any of the lower levels. The password for the 1
st
(highest) level is set to zero "0" by default. Contact ComAp technical support in case that the
password of your unit is lost and needs to be re-issued.
Entering the password
The password must be entered prior adjusting setpoints that are password-protected. Password is
located in the first group of setpoints and the way how to enter or change password is similar to
change of setpoints.
To Next Page
Loading...
Need help?
General
