InteliPro, SW version 1.4, ©ComAp – April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
Installation may be done by qualified personnel only.
To avoid personal injury do not perform any action not specified in this guide!!!
NOTE:
ComAp believes that all information provided herein is correct and reliable and reserves the right to
update at any time. ComAp does not assume any responsibility for its use unless otherwise expressly
undertaken.
Installation data
Unpacking the unit - what is in the package
The package contains:
InteliPro unit
Relay Card CT2-REL2 plug-in module (plugged in the unit)
Mounting holders
Terminal blocks
NOTE:
The package does not contain any communication module nor any extension module. The required
module should be ordered separately.
Mechanical mounting
The unit is to be mounted onto the switchboard door. Requested cutout size is 175x115mm. Use the
screw holders delivered with the unit to fix the controller into the door as described on pictures below.
To Next Page
Loading...
Need help?
General
