ComAp InteliPro - InteliPro Binary Input Configuration; Binary Alarm Configuration Items; Functional Input Configuration Items

InteliPro, SW version 1.4, ©ComAp – April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
4-7
Standard conformity ...................................................................................................................... 46
Binary inputs ................................................................................................................................. 46
Binary outputs ............................................................................................................................... 47
Analog inputs ................................................................................................................................ 47
Mains measurements ................................................................................................................... 47
NVD and Sync Check measurement ............................................................................................ 47
Remote communication interface ................................................................................................. 48
Extesion modules interface ........................................................................................................... 48
Interface to other controllers ......................................................................................................... 48
Relay Card CT2-REL2 .................................................................................................................. 48
Recommended CAN cables ......................................................................................................... 49
Library of binary inputs
Binary alarm and functional input configuration items
Binary Alarm configuration items:
Functional input configuration items:
Check this radio button to configure an
alarm on a binary signal
Input name
Select whether the alarm activates on
opening (NC) or at closing (NO) of the input
Select the alarm type according to the table
below
Check this radio button to configure a
function on a binary signal
Input function
Select whether the function activates on
opening (NC) or at closing (NO) of the input