InteliSys
NT
-AFR-Abstract, SW version 1.0, ©ComAp – December 2006 5
IS-NT-AFR-1.0-Abstract.pdf
Inteli NT application manuals
For each application an appropriate manual is available:
IGS-NT-SPTM-2.0.pdf
IGS-NT-SPI-2.0.pdf
IGS-NT-MINT-2.0.pdf
IGS-NT-COX-2.0.pdf
They include these sections:
• Modes description (OFF, MAN, AUT, …)
• Functions description (e.g. Load shedding, Power management, Start/Stop sequences)
• Protections and alarm management
• Gen-set operation states
• Inputs and outputs
• Setpoints
• List of abbreviations
Inteli NT PC tools manuals
InteliMonitor-2.0.pdf
This manual describes InteliMonitor monitoring PC tool in the following chapters:
• Connection to the controller (Direct, Modem, Internet)
• InteliDDE Server
• Menus description
• Password and access code
GenConfig-2.0.pdf
This manual describes GenConfig configuration PC tool in the following chapters:
• Connection to the controller (Direct, Modem, Internet)
• InteliDDE Server
• Menus description
• Controller configuration steps (Modules, I/O, Setpoints, Protections, History,…)
Inteli common manuals
InteliCommunicationGuide – September 06.pdf
This manual covers communication topics not only regarding IG/IS-NT controllers but also InteliLite
and InteliDrive controllers. It applies to communication between the controller and superior service or
monitoring system but not to communication among the controllers or between the controller and it’s
peripherals (extension modules, ECU).
It is divided into following chapters:
• Local connection
• Remote connection
• Modem connection
• Internet connection
• Active call, SMS, email
• Modbus description
• I-LB, IG-IB communication units
• Modem recommendations
• Recommended converters
To Next Page
Loading...
